As the 2.2 inch flex sensor is bent, the resistance of the flex sensor increases when the metal pads are on the outside of the bend. This sensor is used in applications like Glove Controlled Humanoid Hand, where you want the motors of the humanoid hand to mimic the hand of the glove wearing user.
The connector of this sensor is bread board friendly. The usable range of the sensor can be flexed without any problem, but care must be taken to not flex or strain the base of the sensor.
To incorporate this sensor into your project use it in a voltage divider with a resistor of value between 10K and 100K. On details of how to use this sensor with an Arduino, check out the link below.
|Number of Pins
||2 : Vcc, GND
The Chineduino Uno is a clone of the Arduino Uno microcontroller board based on the ATmega328 with 1..
This is a set of five, 32 cm long, 1 pin Female-to-Female header jumper wires.
The Chineduino Mega 2560 is a clone of Arduino Mega microcontroller board based on the ATmega2560. I..
The Chineduino Lilypad is a clone of the Lilypad Arduino 328 main microcontroller board designed to ..
Create your own line follower or edge avoider robot with this complete kit.Includes:1 ATmega8 Develo..
Create your own cellphone controlled DTMF robot with this complete kit.Includes:1 Boot Board1 A-to-B..
The Chineduino Lilypad is a clone of the Lilypad Arduino USB microcontroller board designed to be in..
The Chineduino LilyTiny is a clone of the LilyTiny Arduino microcontroller board designed to be inte..
Digispark is an Attiny85 based microcontroller development board similar to the Arduino line, only c..
Rated in the Top 2 3D Printers of 2015, FlashForge Creator Pro is built for beginners and profession..
INR 89,000.00 INR 112,300.00
Rated in the Top 2 3D Printers of 2015, FlashForge is built for beginners and professionals alike.Dr..
INR 109,900.00 INR 135,000.00
Rated in the Top 2 3D Printers of 2015, FlashForge is built for beginners and professionals alike.Fi..
INR 49,900.00 INR 64,999.00
Magician = Arduino UNO + 0.8A Motor Driver + Servo Shield + Sensor Shield
The Magician' Dual 0.8A..
INR 1,990.00 INR 2,700.00
Mini Driver = Arduino NG + 2A Motor Driver + Servo Shield + Sensor Shield + Bluetooth Shield + ISP P..
INR 1,600.00 INR 2,999.00
This fun robotic claw is ideal for those who love all things robotic! Simple instructions and suppli..
INR 750.00 INR 1,200.00
Spider = Arduino Mega + Servo Shield + Servo Expansion Shield
This programmable controller from D..
INR 6,200.00 INR 10,499.00